一个工作周期内混凝土搅拌站主机至少应清洗1次.每天生产结束后,则应对搅拌站主机进行全面的清洗,方法是:在清洗过程中,将水及少许石子放进搅拌主机内搅拌5~10 min,清洗后将机内物料全部清除,不得有积水、积料;停机后再冲洗管道,清除搅拌罐内外灰尘和粘附的混凝土.一般情况下,JS1000型搅拌主机加水约150~180 kg左右,其他型号主机可据此增减,也可自备高压水枪进行清理.
A working cycle in the concrete mixing station host at least 1 times. The daily production should be cleaned after the end is to thoroughly clean the mixing station host, the method is: in the process of cleaning, water and a few stones into the mixing console in 5~10 min after mixing, cleaning machine material in the water is not clear all. And the accumulation of the material; stop after washing pipe, remove dust and mixing tank and the adhesion of concrete. In general, JS1000 type main mixing water about 150~180 about kg, other types of host can then change, also can bring their own water cannons to clear.
混凝土搅拌站主机日常应该怎样维护与清理
How to maintain and clean up the main engine of concrete mixing station
在冲洗搅拌主机料门时,应避免上部冲洗下的积料形成异物卡滞料门现象.搅拌过程中,若混凝土运输车较长时间没有到位(超过20~30 min,尤其在夏季),应加水对搅拌机进行简易清洗.
During flushing and mixing main material gate, we should avoid the phenomenon of foreign matter stuck and sluggish door when washing up the upper part. During the mixing process, if the concrete truck is not in place for a long time (over 20~30 min, especially in summer), we should add water to clean the mixer.
混凝土搅拌站设备正常生产期间,要定期检查搅拌筒内及搅拌轴上混凝土的凝固情况,如有凝结应及时按要求进行人工铲除.人工清理搅拌筒前,必须切断电源、气路,放净余气、锁好控制室;人工清理搅拌筒时,严禁猛烈敲击搅拌轴、搅拌臂及搅拌叶片.
During the normal production of concrete mixing station equipment, to regularly check the mixing barrel and the stirring shaft concrete solidification condition, such as a setting should be timely manual eradication as required. Manual cleaning of mixing drum, must cut off the power supply, gas, gas, put the net lock control room; manual cleaning of mixing drum, non violent a stirring shaft, stirring arm and |
免责声明： 以上所展示的信息由会员自行提供，内容的真实性、准确性和合法性由发布会员负责，企业录对此不承担任何责任。如有侵犯您的权益，请来信通知删除。